hakkında şirket haberleri Ultrasonic welding machine maintenance

Precautions and equipment maintenance

Precautions

1. Do not place the machine or pressure and overheating damp places, do not place the machine above the fluid composition, usually pay attention to cleanliness, wipe any time, but not the use of liquid cleaning.

2. Do not touch the horn when the oscillation, in order to avoid burns, automatic operation, press the emergency stop button in case of danger (STOP).

3. During operation (with the load state), current overload alarm, the need to reduce stress, reduce the amplitude, if adjusted, still can not be lowered, please contact our deal.

4. The machine's vibrator and vibrating machine has made in the high-voltage lines, in addition to external operation to adjust, do not repair the inner parts of machine.

5. The machine's air filter (AIR FILTER) If there is water inside the residence, please feel free to exclude, shall from time to time when the air compressor to clean water as excessive moisture.

6. Ground wire must be grounded, and is not connected to the power of the "ground" on the high pressure in order to prevent leakage.

7. Vibrator and horn not that do over 360 °of rotation, in order to avoid broken high-voltage lines.

Ultrasonic Welding machine maintenance

1. The welding head, the bottom mold and work often keep things clean.

 2. Regularly check the cable connector is loose.

 3. Clean the air filter on a regular basis, you should use detergent or water, do not use solvents of the play.

 4. Mechanical regular cleaning, but not the use of liquid cleaning oscillation top boxes do not put the weight or fluid substance.

 5. Keep the work place air flow, ambient temperature is not too high. (40 ℃ below).

 6. Lift the trench, such as screw regularly wipe yellow grease, and keep clean.

 7. Even when moving the machine, the oscillation box should be separated from the body (open cable outlet), moving even have to be careful, not by the impact.

 8. When not in use for a long time, connect the unit exterior cleaning, oiling and maintenance, and the envelope attached to the machine's cover in a dry ventilated place.

 9. Monthly control box should open the lid, with clean water without air gun, remove dust box, in order to maintain good ventilation cooling parts.